Filter Changes (eflow)
The Water Leak Warning Light indicates that a leak may have been detected within the eflow. There are a few considerations for troubleshooting this type of alert.
Changing the Filters
Filters should be changed once the LED indicator on the front panel is no longer illuminated. Below are the steps to change the filters in the eflow.
1. Open the magnetic side cover.
2. Remove the cartridge you are replacing by twisting it to the left and discard in the proper manner.
3. Install new cartridge(s) by turning them to the right to re-attach to the filter heads.
4. Press and hold the reset button next to the filter(s) replaced for 5 seconds, or until the filter life resets.
5. If changing the pre- or post-filter, it is recommended to purge carbon fines by turning on the faucet and allowing water to flow through the system for 10 minutes. Then close the RO faucet.
-
- If changing the RO membrane, a system flush will need to be performed.
6. Replace the magnetic side cover.